LED Descriptions
Method 1: Extending Your WiFi Network Using Web UI
Signal LED
Solid blue
Solid red
O The repeater does not connect to your WiFi router.
The repeater is too far away from the router.
Relocate the repeater closer to the router.
The repeater has connected to your existing WiFi
router/modem, and its position is proper.
WPS LED
On
Blinking
O
A WPS connection has been established.
A WPS connection is being established.
The WPS function is disabled.
Power LED
Solid on
The repeater has started.
The repeater is starting.
The repeater is not powered on.
O
Blinking
1
Power on the Repeater
Plug the repeater into a power outlet
near the router in the same room.
Wait until the PWR LED turns solid blue.
3. Select a WiFi network (SSID) you want to
extend.
4. Enter the password of the WiFi network
you want to extend.
Select a WiFi network you want to
extend…
My_home_wi
Rescan Switch Mode
Your existing WiFi network
Enter the password of “My_home_wi”
My_home_wi_5GEXT
Password of the extended network is
same as your existing WiFi network.
The extended WiFi network
SSID
Back Extend
Password (5-32 characters)
Conrm
Next Not Now
http://re.rockspace.local
2
Extend Your WiFi Network
1. Connect your WiFi device to the repeater's
WiFi network rockspace_EXT.
Ensure that the Mobile Data (if any)
is disabled.
WLAN
rockspace_EXT
2. Start a web browser, enter
hp://re.rockspace.local or
192.168.0.254 in the address bar to log in.
Create a login password for later attempts
(recommend).
Wait a moment, the Extended successfully!
page appears.
3
Relocate the Repeater
1. For better performance, plug the repeater into an
outlet halfway between the router and the WiFi
dead zone.
3. Connect your WiFi devices to the repeater using the
SSIDs set by yourself, or your router's SSID with a
sux _EXT/5GEXT, and using the WiFi password
same as your WiFi router.
2. Wait until the Signal LED turns blue. If not, relocate
the repeater closer to the router.
The location you choose must be within the range
of your existing WiFi network.
WiFi router
Antennas upward and vertical to the ground
Blue: Successful connection
Red: Failed connection
RSD0608
Signal
English
PWR
Use the end of a paper clip or a similar object to press and
hold this button for about 8 seconds with power on, and
then release it to restore the extender to factory settings.
DescriptionButton
RST
AC1200 Dual Band WiFi Repeater
Model: RSD0608
To Next Page
Need help?
General
