26
Preparing an SD Memory Card
(continued)
fig.SDlock.eps
The contents of the memory card can be protected by
write protecting it. To write protect a card, slide the write
protect switch on the side of the memory card to the
“LOCK” position.
Unlock write protect to delete data on the card.
The memory card write protect feature (LOCK)
Protect switch
In some cases when you insert an unused SD memory card that you purchased at a
consumer electronic retailer, or an SD memory card that has been used with a computer
or digital camera, the screen may indicate “Unknown Format. Format?”
In order to use this SD memory card with the CD-2i, you’ll need to format the card.
Proceed as follows to format the card.
1 To begin formatting, press the [ENTER] button.
fig.SDcard05.eps
2 If you’re sure you want to proceed, press the [ENTER] button.
(If you decide to cancel, press the [EXIT] button.)
fig.SDcard06.eps
The screen will indicate “Processing..,” and the card will be formatted. When formatting
is completed, you’re returned to the audio source screen.
If the screen indicates “Unknown Format”
●
While formatting is in progress, you must never turn off the power or remove the SD
memory card.
●
When you format an SD memory card, any data that was on that card will be erased. Data
that’s been lost in this way cannot be recovered. Please make sure that you really want to
format the card.
Note
CD-2i_e.book 26 ページ ２０１０年３月１５日 月曜日 午前１０時１５分
To Next Page
Loading...
Need help?
General
