Important Notes When Using a Latch-type Footswitch Pedal
Normally, the on/off state of the footswitch pedal takes precedence over the control panel for switching EFX, delay, or reverb on
and off.
However, the on or off states stored in memory using the SOLO function take precedence when saved SOLO-function panel
settings are called up. Such cases may result in conflicting indicator displays on the control panel and the footswitch pedal, but this
is not a malfunction.
To make the indicator displays match up
Depress the footswitch pedal whose indicator display is different.
Make it match the indicator display on the control panel.
To make the on/off state of the footswitch pedal take priority at all times
On this unit, you can use either of the following settings to control operation when the panel settings for EFX, delay, and
reverb are called up using the SOLO function.
• Make the on/off state of the footswitch pedal always take priority
• Make the on/off state saved using the SOLO function take priority (default)
1. How to make the on/off state of the footswitch pedal always take priority
Hold down the TAP and SELECT switches at the same time and switch on the power.
2. How to make the on/off state saved using the SOLO function take priority
Hold down the TAP and TUNER switches at the same time and switch on the power.
* The changed setting remains in memory after the power is switched off.
To Next Page
Loading...
Need help?
General
