92
MFX/IFX Parameters
21 Rotary
This simulates a classic rotary speaker of the past.
Since the operation of the high-frequency and low-frequency rotors
can be specied independently, the distinctive modulation can be
reproduced realistically. This is most eective on organ patches.
L in
R in
L out
R out
Parameter Value Explanation
Speed SLOW, FAST
Simultaneously switch the rotational speed of
the low frequency rotor and high frequency
rotor.
SLOW: Slows down the rotation to the Slow
Rate.
FAST: Speeds up the rotation to the Fast Rate.
Woofer Slow Speed 0.05–10.00 [Hz]
Slow speed (SLOW) of the low frequency
rotor
Woofer Fast Speed 0.05–10.00 [Hz] Fast speed (FAST) of the low frequency rotor
Woofer Acceleration 0–15
Adjusts the time it takes the low frequency
rotor to reach the newly selected speed when
switching from fast to slow (or slow to fast)
speed.
Woofer Level 0–127 Volume of the low frequency rotor
Tweeter Slow Speed 0.05–10.00 [Hz]
Settings of the high frequency rotor
The parameters are the same as for the low
frequency rotor
Tweeter Fast Speed 0.05–10.00 [Hz]
Tweeter Acceleration 0–15
Tweeter Level 0–127
Separation 0–127 Spatial dispersion of the sound
Level 0–127 Output Level
22 VK Rotary
This type provides modied response for the rotary speaker, with the
low end boosted further.
This eect features the same specications as the VK-7’s built-in rotary
speaker.
L in
R in
L out
R out
Parameter Value Explanation
Speed SLOW, FAST
Rotational speed of the rotating speaker
SLOW: Slow
FAST: Fast
Brake OFF, ON
Switches the rotation of the rotary speaker.
When this is turned on, the rotation will
gradually stop. When it is turned o, the
rotation will gradually resume.
Woofer Slow Speed 0.05–10.00 [Hz] Low-speed rotation speed of the woofer
Woofer Fast Speed 0.05–10.00 [Hz] High-speed rotation speed of the woofer
Woofer Trans Up 0–127
Adjusts the rate at which the woofer rotation
speeds up when the rotation is switched from
Slow to Fast.
Woofer Trans Down 0–127
Adjusts the rate at which the woofer rotation
speeds up when the rotation is switched from
Fast to Slow.
Woofer Level 0–127 Volume of the woofer
Tweeter Slow Speed 0.05–10.00 [Hz]
Settings of the tweeter
The parameters are the same as for the
woofer.
Tweeter Fast Speed 0.05–10.00 [Hz]
Tweeter Trans Up 0–127
Tweeter Trans Down 0–127
Tweeter Level 0–127
Spread 0–10 Sets the rotary speaker stereo image.
Low Gain -15–+15 [dB] Gain of the low range
High Gain -15–+15 [dB] Gain of the high range
Level 0–127 Output Level
OD Switch OFF, ON Overdrive on/o
OD Gain 0–127
Overdrive input level
Higher values will increase the distortion.
OD Drive 0–127 Degree of distortion
OD Level 0–127 Volume of the overdrive
To Next Page
Loading...
Need help?
General
Weight and Dimensions
