1
Q&A
Q1. How do I output the metronome sound?
Ans 1-1.
The procedure for outputting the metronome sound is:
1.
Press [MENU].
2.
Select “11 Metronome.”
3.
Press [ENTER].
4.
Select Mode.
5.
Select Output.
Ans 1-2.
The procedure for outputting the metronome sound is:
1.
In the SEQUENCE screen, press [REC] to access RECORDING PARAMETER.
2.
At this time you can also make the same settings by pressing [F3(Metronome)].
Q2. How do I use the VALUE dial to move the time location?
Ans.
Holding down [JUMP] and turning the VALUE dial to move in steps of one tick.
You cannot move the time location by using the VALUE dial alone.
Q3. How do I select a sound for a MIDI track?
Ans.
To select a sound for a MIDI track:
1.
Make the current track the MIDI track for which you want to select a sound.
2.
Press [F1 (Track Param)].
3.
Use Output Assign to select the part you want to use.
If at this point in the procedure you find the sound you want to use, you're done.
If you want to assign a different sound (patch) to the part:
4.
Press [INSTRUMENTS].
5.
Make the current part the part whose assignment you want to change.
6.
Press [F4 (Library)].
7.
Select the sound (patch) that you want to assign.
8.
Press [F5 (Use This)].
9.
Return to step 1 and select a part.
If at this point in the procedure you still have not found the sound you want to use, you'll need to create your own
original patch by sampling or importing.
To Next Page
Need help?
General
