57
Using the Convenient Functions in Performances
You can also register the Setups you like and use frequently to the TONE SELECT
buttons. This function allows you to select Setups more quickly.
You can register a total of 40 setups, ten tones in each of the four banks, to the
Favorite Setups.
1
Press [SETUP] to call up the Setup you want to register.
Make sure [NUM LOCK] is off at this time.
2
Press [F2] to select the bank to which you want to register the Setup.
3
Hold down [F1] and press the TONE SELECT button for the
registration destination.
The Setup is registered to the button that is pressed.
Registering the Setups You Like (Favorite Setups)
When the Tone screen is displayed, the [SETUP] indicator lights and the Setup
screen appears when CURSOR [ ] is pressed.
From the Setup screen, you can get back to the Tone screen by pressing CURSOR
[ ].
However, the Tone Wheel screen is displayed if “TW-Organ 1–10” is selected for any
Part in the Tone screen.
Refer to “Simulating the Creation of Organ Tones (Tone Wheel Mode)” (p. 53).
Setups indicated by a “RHY:”
efore the name let you enjoy
performing with a session-like
feel while playing a Rhythm.
Be sure to check it out.
Selecting Setups Other Than the Favorite Setups
1. Press [SETUP], getting the indicator to light.
2. Press [INC]/[DEC] or TONE SELECT buttons to select the Setup to be
called up.
After [INC]/[DEC] is pressed, the following screen appears; the Setup screen
then reappears after a few moments.
The screen does not change when the TONE SELECT buttons are used to input
Setup numbers. Press [ENTER] afterwards to set the number.
fig.Q2-18g
Settings registered in the RD-
700SX are not deleted even
when the power is turned off.
RD-700SX_e.book 57 ページ ２００６年３月２３日 木曜日 午後２時５２分
To Next Page
Loading...
Need help?
General
