Royal Enfield Bullet 350 User Manual

20
STARTING
 Ensure Gear is in Neutral position and the Neutral
lamp is glowing in the speedometer. To shift into
neutral, move the motorcycle back and forth
gently, while simultaneously shifting the gear.
C AU T I O N
Do not attempt to shift gears without moving the
motorcycle back and forth as it will damage the gears
mechanism.
Pull Out
 Turn fuel tap to ‘ON’ “RESERVE”
Position.
 Use choke if required in cold
climatic conditions (below 20
0
C)
 Switch ON Ignition and the Stop
Switch to “RUN” Position.
USING ELECTRIC START (BULLET 350-ES)
 Depress and Hold the Clutch Lever.
 Press Starter Button and hold till
Engine starts. Do not release the
button before Engine starts.
USING THE KICK START LEVER
 Slowly Crank Engine with the Kickstarter lever till a
resistance is felt in the lever. Slightly crank slowly
and further till the compression eases over.
 Release Kickstarter lever to enable it to come to its
top resting position.
 Apply a powerful swinging Kick on the lever to
start the engine. It may be necessary to open the
throttle, very slightly, when starting on choke/first
time in the morning.
 Release Choke if applied and allow Engine to run
at idling speed for a few minutes.

Royal Enfield Bullet 350 Specifications

General

Engine Type	Single Cylinder, 4 Stroke, Air Cooled
Displacement	346 cc
Max Power	19.1 bhp @ 5250 rpm
Max Torque	28 Nm @ 4000 rpm
Transmission	5 Speed Constant Mesh
Fuel Capacity	13.5 Liters
Brakes Rear	153 mm Drum
Tyre Size Front	3.25 x 19
Tyre Size Rear	3.25 x 19
Seat Height	800 mm
Ground Clearance	135 mm
Wheelbase	1370 mm
Brakes Front	280 mm disc
Fuel System	Fuel Injection