AUGER BITS
LES EMBOUTS DE TARIÈRE
PUNTAS DE LA BARRENA
AC4DRT/AC6DRT/AC8DRT/AC10DRT
For use with Ryobi™ P2903 and RY40701 Hole Augers.
NOTE: These instructions supplement the ASSEMBLING THE HOLE
AUGER instructions in your operator’s manual.
WARNING:
This insert sheet is not a substitute for reading the operator’s manual.
To reduce the risk of injury or death, user must read and understand
operator’s manual before using this product.
WARNING:
To prevent accidental starting that could cause serious personal injury,
always remove the battery pack from the product when assembling parts.
ASSEMBLING THE HOLE AUGER
See Figures 1 - 2
n Stand the auger bit (B) upright with tip pointing down.
nRemove the locking pin (A) from the auger (B).
n Install the drive shaft (D) into the auger (B).
nAlign the holes on the auger (B) and drive shaft (D).
nInsert the locking pin (A) and secure with the pin clip (C).
Please consult your operator’s manual for further information or contact
Ryobi Customer Service at 1-800-525-2579.
998000430
10-28-20 (REV:01)
Fig. 1
Fig. 2
C
A
B
B
C
A
TECHTRONIC INDUSTRIES POWER EQUIPMENT
P.O. Box 1288, Anderson, SC 29622 USA n 1-800-525-2579 n www.ryobitools.com
Model/item number on product may have additional letters at the end. These letters designate
manufacturing information and should be provided when calling for service.
D
To Next Page
Need help?
General
