Ryobi ONE+ PAD01 User Manual

4 - English
IMPORTANT SAFETY INSTRUCTIONS
BLUETOOTH
®
LICENSE STATEMENT
The BLUETOOTH
®
word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such
marks by TECHTRONIC POWER TOOLS TECHNOLOGY LIMITED is under license. Other trademarks and trade names are
those of their respective owners.
FCC COMPLIANCE
NOTE: This device complies with part 15 of the FCC RULES and Industry Canada license-exempt RSS standard(s). Opera-
tion is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
NOTE: The grantee is not responsible for any changes or modifications not expressly approved by the party responsible
for compliance. Such modifications could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
 Reorient or relocate the receiving antenna.
 Increase the separation between the equipment and receiver.
 Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
 Consult the dealer or an experienced radio/TV technician for help
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or
lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference to other users, the
antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than
that necessary for successful communication.
SUPPLIER’S DECLARATION OF CONFORMITY
RYOBI 18 VOLT One+™ SPEAKER Model: PAD01
The responsible party declares that this device complies with Part 15 of the FCC Rules. Operation is subject to the follow-
ing two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Report No.:
Responsible Party: One World Technologies
Address: 115 Innovation Way, Anderson, SC 29621
Telephone: (864) 226-6511
Fax: (864) 965-6274
Printed Name/Title: John Collins / Director Regulatory
Signature:

Ryobi ONE+ PAD01 Specifications

General

Brand	Ryobi
Model	ONE+ PAD01
Category	Speakers
Language	English