12
Problem Possible cause Solution
Handle is not in position.
Carriage bolts are not seated
properly.
Adjust the height of the handle and
make sure the carriage bolts are
seated properly.
Cam handle is not tightened. Tighten cam handle.
Mower is not starting.
Battery is low in charge. Charge the battery.
Battery is either inoperable or will not
take a charge.
Replace the battery.
Mower is cutting grass unevenly.
Lawn is rough or uneven or cutting
height not set properly.
Move the wheels to a higher position.
All wheels must be placed in the
same cutting height for the mower to
cut evenly.
Mower is not mulching properly.
Wet grass clippings are sticking to
the underside of the deck.
Wait until the grass dries before
mowing.
Mower is hard to push.
High grass, rear of mower housing
and blade are dragging in heavy
grass, or cutting height too low.
Raise the cutting height.
Mower is not bagging properly. Cutting height is set too low. Raise the cutting height.
Mower is vibrating at higher speed.
Blade is unbalanced, excessively or
unevenly worn.
Replace the blade.
Motor shaft is bent.
Stop the motor, remove isolator key
and battery, disconnect the power
source, and inspect for damage.
Have it repaired by an authorised
service center before restarting.
Motor stops while cutting.
Cutting height is set too low. Raise the cutting height.
Battery has no power. Charge the battery.
If these solutions do not solve the problem contact your authorised service dealer.
To Next Page
Loading...
Need help?
General
