PREPARATION
2.1 Safety Instructions
· There is possibility of danger to life due to electrical shock and high voltage.
· Do not touch non-insulated parts or cables.
· Disconnect the inverter from voltage sources and make sure it cannot be reconnected before working on the device.
· Do not disconnect the DC connector under load.
· Do not touch the live parts and cables inside the inverter during operation, it might result in burning or death.
· To prevent risk of electric shock during installation and maintenance, please make sure that all AC and DC terminals are
disconnected.
· Do not touch the surface of the inverter while the housing is wet, otherwise, it might cause electrical shock.
· Do not stay close to the inverter while there are severe weather conditions including storm, lighting, etc.
· Before opening the housing, the SAJ inverter must be disconnected from the grid and PV generator; you must wait for at least
five minutes to let the energy storage capacitors completely discharged after disconnecting from power source.
Danger to life due to fire or explosion
· In the event of fault, do not conduct any direct action on the inverter.
· Disconnect PV array from inverter via an external disconnection device. If there is no external disconnection device present,
wait until no more DC power is applied to the inverter.
· Disconnect the AC circuit breaker, or keep it disconnect if it is tripped, and secure it against reconnection.
· Do not touch non-insulated parts or cables.
· Do not touch non-insulated parts or cables.
·The installation, service, recycling and disposal of the inverters must be performed by qualified personnel only in compliance
with national and local standards and regulations.
·Any unauthorized actions including modification of product functionality of any form may cause lethal hazard to the operator,
third parties, the units or their property. SAJ is not responsible for the loss and these warranty claims.
·The SAJ inverter must only be operated with PV generator. Do not connect any other source of energy to the SAJ inverter.
·Be sure that the PV generator and inverter are well grounded in order to protect properties and persons.
·The solar inverter enclosure will become hot during operation. Please do not touch the heat sink or enclosure during operation.
·Risk of damage due to improper modifications.
·Public utility only.
·The solar inverter is designed to feed AC power directly to the public utility power grid; do not connect AC output of the inverter
to any private AC equipment.
To Next Page
Loading...
Need help?
General
