Removing any residual matter inside the water supply line after
installing lter.(Optional)
1.Turn ON the main water supply & turn OFF the
valve to the water supply line.
2.Run water through the dispenser until the water
runs clear (approx. 1L). This will clean the water
supply system and remove air from the lines.
3.Additional ushing may be required in some
households.
4.Open the refrigerator door and make sure there
are no water leaks coming from the water lter.
NOTE
•
A newly installed water lter cartridge may cause water to briey spurt from the water
dispenser. This is due to air getting into the line. It should pose no problem to operation.
Check the amount of water supplied to the ice tray. (Optional)
1. Lift up the icemaker bucket and gently pull out of the freezer.
2. When you press the Test button for 1.5 seconds, the ice cube container is
lled with water from the water supply tap after ice tray is twisted. Check to
make sure the amount of water is correct(see the illustration below).
If the water level is too low, the ice cubes will be small. This is a water
pressure problem from with in the main water pipes, not the refrigerator
Ice maker
1
2
Check the water level
Test button
Feeler Arm
Installation
To Next Page
Loading...
Need help?
General
