BN68-05448A-01
QUICK START
GUIDE
Welcome to your new Smart TV!
The following instructions cover assembling, connecting, and setting up your new TV. Make
sure you have the accessories listed below.
Included in this box
Remote Control Stand Parts and Cables
x 4
Power Cord Wall mount adapter
Remote Control IR extender
Batteries (AAA x 2)
Also included: User Manual
Step
1
Attach the TV to
the Stand
Step
2
Connect video
devices
Step
3
Insert the
batteries into the
remote control
Step
4
Power on and
start the initial
setup
Warning: Screens can be damaged
from direct pressure when handled
incorrectly. We recommend lifting the
TV by the edges, as shown.
Step 1 Installing the Wall Mount (Optional)
Wall or Ceiling Mounting:
If you mount this product on a wall, it should be mounted only as recommended by the manufacturer. Unless it is correctly mounted, the product
may slide or fall, causing serious injury to a child or adult, and serious damage to the product.
1A 1B
Loosen four screws on the back of the TV.
Make sure that at least two people are holding each side of the TV
before removing the stand as shown in the illustration.
1C
Make sure that the remote control sensor does
not touch the bottom when detaching the stand,
to mount the TV on a wall.
After detaching the stand from the TV, re-insert the screws into the stand to block the screw holes and store
the screws.
[UF6300-75inch-QSG]BN68-05448A-01ENG.indb 2 2013-07-30 �� 4:50:24
To Next Page
Need help?
General