第 3 页 共 4 页
CHECK THERMOSTAT OPERATION
1. The description of thermostat working condition：
Standby：when power input, all the lights no display
Power status：Shortly press the button ,indicator A(red ) turn on as long as there is power
to the unit.
Shutdown status ：On state, indicator A(red ) is long bright. Shortly press the button,
indicator A(red )turn off indicates it is in shutdown status mode, thermostat shut down all
output.
Working state: Indicator B(green) turns on as long as the heating device is energized.
Power Failure Memory Function：In the operation, power after the phone call, automatic
memory before the power switch machine state。
Forced output function：In the shutdown state，Long time 8 seconds press until a
green light.Open all output，Don't accept emission control signal or launch control
damage cases effective，The mandatory output state，According to lift off buttons
short back to the state。
Communication signals: When indicator C(yellow ) is flashing that indicates the
thermostat is entered to receive communication signals. Yellow LED blink two times.
2. Select the limit of temperature value
Switch on the thermostat, indicator A(red ) turn on .Long press the button over 3
second, indicator A(red ) turn off, green one is blinking. Shows the thermostat enters to
the temperature limit value selection mode. Press the button to select the temperature you
want. When the limit value is 30℃,the LED A and B(both green) would be blinking. When
the limit value is 40℃,the LED A(green) and C(yellow) would be blinking. When the limit
value is 55℃,all of the indicators would be blinking. If only LED A(green) blinking that
indicates the thermostat cancel limit value protection.
To exit the menu and return to the normal operation, press the button over 3 second. If no
keys are pressed within 8 seconds the thermostat will exit the menu.
3. Code match：
When the Control Centre is in the code match mode, Switch off the thermostat, long
press the button for 3 second to enter the code match mode and LED C (yellow) lit up. If
the Control Centre and receiver code match successfully, LED C (yellow) flashes 6
times ,saves the current setting and exit automatically.
Otherwise it means not done , the
thermostat will exit the menu after 20 second and need to recode.
4. CHECK THERMOSTAT OPERATION
The unit will be controlled via air sensor in the Control Centre and the Control Centre will
determine to activate/deactivate heating system by comparing set temperature with room
temperature. Press ▲ to adjust Control Centre setting temperature is 1℃ higher than
room temperature .The Control Centre will emit signals to the Receiver asking to turn on
the heating device. LED C(yellow) on the Receiver flashes means Receiver has received
the signals. LED B(green) turns on means heating device is energized. Press ▼ to adjust
To Next Page
Loading...
Need help?
General
