WARNING ! Electrical Shock Hazard
Turn off power at the main service panel by removing the fuse or switching the appropriate circuit breaker to the OFF
position before removing the existing thermostat.
1. Turn off power to the heating and cooling system by removing the fuse or switching the appropriate circuit breaker
off.
2. Place the system switch (EMER/HEAT/OFF/COOL) in the OFF position.
3. Place the FAN (ON /AUTO) switch in the AUTO position.
4. Gently pull the cover straight off the base. (See figure 1.)
5. Put the thermostat base against the wall where you plan to mount it. (Be sure the wires will feed through the wire
opening in the base of the thermostat.)
6. Mark the placement of the mounting holes.
7. Move the base out of the way. Drill mounting holes. Use a hammer to tap in the supplied anchors into the mounting
holes.
8. Fasten the base loosely to the wall as shown in Figure 1, using two mounting screws. Place a level against the
bottom of the base and adjust until level, then tighten the screws. (Leveling is for appearance only, and will not affect
thermostat operation.)
9. Insert stripped, labeled wires into matching wire terminals. See “Wiring Diagrams”, Figure 2.
CAUTION: Be sure exposed portions of wires do not touch other wires.
To Next Page
Loading...
Need help?
General
