EasyManuals Logo
Home>Schaerer>Coffee Maker>Coffee Club

Schaerer Coffee Club Cleaning Procedures

Schaerer Coffee Club
2 pages
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #2 background imageLoading...
Page #2 background image
Schaerer AG w / QRC SC Club | V01 | 08/2018
Postfach 336 QRC_SCClub_w_EN
Allmendweg 8 V01 / 08/2018
CH-4528 Zuchwil, Switzerland
info@schaerer.com / www.schaerer.com N° 020967
4 5 6
Mix 5 ml of Schaerer special cleaner with
0.5 litres of warm drinking water.
Lay all individual parts, including the clean-
ing brush, into the prepared cleaning liquid
(completely covered with cleaning uid).
After 5 hours, thoroughly clean all parts
with the brush.
Very thoroughly clean all parts with pure
drinking water.
Assemble the milk foamer.
Moisten the parts to be assembled, do not
grease
Assemble the parts and press down rmly.
Reinsert the milk foamer into the outlet.
Cleaning the milk hose
Put one end of the milk hose to the other
parts into the cleaning liquid.
Lay the rest of the milk hose into the clean-
ing liquid lengthwise.
All parts must be completely covered with
the cleaning liquid.
This process prevents air bubbles from
remaining in the milk hose.
7
Cleaning with a powder system –
mixer
Perform a mixer rinse.
Open doors.
Pull the mixing cup forwards using the
handle.
Lift the mixing cup slightly so that any
remaining water runs out.
Pull o󰀨 the mixer hose, from the mixing cup
to the outlet, and take it out of the guide.
The mixer's propeller is now visible.
Clean the propeller with a cloth.
Disassemble the two-part mixing cup.
Clean more often depending on the powder
used.
Clean both mixing cup parts and the mixer
hose under warm, running drinking water.
Let the parts dry fully.
At the time of reassembly, all openings
must point in the same direction.
Insert mixer hose into the outlet through
the guide.
Reinsert mixing cup until it engages.
Attach the mixer hose onto the mixing cup.
Cleaning the bean hoppers
Briey press on/o󰀨 switch (approx. 1 sec-
ond). Disconnect the power plug.
Remove the bean hopper lids, empty and
clean with a damp cloth.
Clean the locking elements in the bean
hoppers with the supplied brush.
Allow the bean hoppers to dry completely.
Seal completely with the lid.
Bean hoppers can be cleaned at regular inter-
vals as required. Recommendation: monthly.

Other manuals for Schaerer Coffee Club

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Schaerer Coffee Club and is the answer not in the manual?

Schaerer Coffee Club Specifications

General IconGeneral
BrandSchaerer
ModelCoffee Club
CategoryCoffee Maker
LanguageEnglish

Related product manuals