sharkclean.comsharkclean.com
ASSEMBLY SETTINGS
NOTE: Use the floor selector to toggle between Bare Floor and Carpet settings.
NOTE: For deep cleaning per ASTM F 608 (embedded dirt in carpets) please use the Carpet setting.
NOTE: Select Carpet for stuck-on dust and debris.
Power Button
Press the Power button to begin
vacuuming. Press again to turn
o power. Press the FLOOR TYPE
button to toggle between Bare
Floor and Carpet settings.
1 2
3
4. For compact storage, hang the handheld
vacuum from the Storage Hook on the wand.
1. Insert Wand into Floor Nozzle. 2. Insert Handheld Vacuum into wand.
3. Snap the Onboard Storage Clip onto the
wand, then place accessories in the holder.
Ensure all connections click securely into place.
(Snap)
(Click)
(Click)
4
Carpet
Press the FLOOR TYPE button to
switch to Carpet setting. The brushrolls
spin faster to pick up debris below the
surface ofyour carpets.
CONTROLS
The control panel is located on top of
the handheld vacuum.
POWER BUTTON
Bare Floor/Small Area Rugs
When powered on, the vacuum will
be in Bare Floor setting. In this setting,
the brushrolls spin slowly to clean bare
floors and small area rugs.
BARE FLOOR SETTING CARPET SETTING
To Next Page
Loading...
Need help?
General
