4
TINSEB537MRR0
Mounting
flange
dRAWER INStALLAtIoN
1. Place the drawer adjacent to the wall or
cabinet opening. Plug the power supply
cord into the electrical outlet.
2. Carefully guide the drawer into the
prepared opening. Avoid pinching the
cord between the oven and the wall.
3. Slide the drawer all the way until the mounting ange is ush
with the face of the cabinet. See Figure 8A.
4. Open the drawer. Using the 4 holes on the drawer as a template,
pre drill the cabinet using a
1
/16" bit. See Figure 8A.
5. Secure the drawer with the 4 screws supplied. See Figure 8B.
4 Screws
Parts supplied
1 Sharp Plaza, Suite 1 • Mahwah, New Jersey 07495-1123
1-800-BE-SHARP (237-4277)
modEL ANd SERIAL NUmBER LoCAtIoN
The name plate includes model and serial number. Open the
Microwave Drawer fully. The label is beyond the back wall of
the microwave cavity facing up from the at surface.
CARE, CLEANING ANd mAINtENANCE
Refer to the Operation Manual for cleaning instructions.
BEfoRE yoU CALL foR SERvICE
Read the BEFORE YOU CALL and operating instruction sections
in your Operation Manual. It may save you time and expense.
The list includes common occurrences that are not the result of
defective workmanship or materials in this range.
Refer to the warranty in your Operation Manual for Sharp’s
toll-free service number and address. Please call or write if you
have inquiries about your microwave product and/or need to
order parts.
May 12, 2014
To Previous Page
Loading...
Need help?
General
