In the interest of user-safety the oven should be restored to its original
condition and only parts identical to those specified should be used.
WARNING TO SERVICE PERSONNEL: Microwave ovens contain
circuitry capable of producing very high voltage and current,
contact with following parts may result in a severe, possibly fatal,
electrical shock. (High Voltage Capacitor, High Voltage Power
Transformer, Magnetron, High Voltage Rectifier Assembly, High
Voltage Harness etc..)
TABLE OF CONTENTS
CONVECTION
MICROWAVE OVEN
Page
PRECAUTIONS TO BE OBSERVED BEFORE AND DURING SERVICE TO
AVOID POSSIBLE EXPOSURE TO EXCESSIVE MICROWAVE ENERGY ..........................INSIDE FRONT COVER
BEFORE SERVICING ...................................................................................................INSIDE FRONT COVER
WARNING TO SERVICE PERSONNEL ........................................................................................................................................1
MICROWAVE MEASUREMENT PROCEDURE ...................................................................................................................2
FOREWORD AND WARNING .............................................................................................................................................................3
PRODUCT SPECIFICATIONS .............................................................................................................................................................4
GENERAL INFORMATION .....................................................................................................................................................................4
OPERATION ......................................................................................................................................................................................................6
TROUBLESHOOTING GUIDE ............................................................................................................................................................12
TEST PROCEDURE ...................................................................................................................................................................................14
TOUCH CONTROL PANEL ...................................................................................................................................................................24
COMPONENT REPLACEMENT AND ADJUSTMENT PROCEDURE ....................................................................31
PICTORIAL DIAGRAM .................................................................................................................................................................................38
CONTROL PANEL CIRCUIT .................................................................................................................................................................. 39
PRINTED WIRING BOARD ..................................................................................................................................................................... 40
PARTS LIST ..........................................................................................................................................................................................................41
PACKING AND ACCESSORIES ........................................................................................................................................................44
SMC1585BSA
SMC1585BBA
SMC1585BWA
S5608SMC1585B
MODEL
SERVICE MANUAL
SHARP CORPORATION
This document has been published to be used for after
sales service only.
The contents are subject to change without notice.
SMC1585BS
*FOR SERIAL NUMBERS* : SMC1585BSA --> 505011 - AND ABOVE
SMC1585BBA --> 503501 - AND ABOVE
SMC1585BWA --> 501901 - AND ABOVE
*Units with Serial Number range (REMARK RED LETTER)
employ a change to the connectors on
various Components, Harnesses and PWB’s.*
SMC1585BSA
SMC1585BBA
SMC1585BWA
To Next Page
Need help?
General
