en HomeConnect
8
2.
To set circulating-air mode (regenerative filter),
press and hold and until indicator 3 appears
on the display.
3.
To set air extraction mode, press and hold and
until indicator 1 appears on the display.
6.17 Switching on the lighting
The lighting can be switched on and off independently
of the ventilation system.
▶
Press .
6.18 Setting the brightness
▶
Press and hold until the required brightness is
reached.
6.19 Switching on the audible signal
Requirement:The appliance is switched off.
▶
Press and hold and at the same time for ap-
prox. three seconds.
a appears on the display.
6.20 Switching off the signal tone
Requirement:The appliance is switched off.
▶
Press and hold and at the same time for ap-
prox. 3 seconds until a signal sounds.
a appears on the display.
7 HomeConnect
This appliance is network-capable. Connecting your ap-
pliance to a mobile device lets you control its functions
via the HomeConnect app, adjust its basic settings
and monitor its operating status.
The HomeConnect services are not available in every
country. The availability of the HomeConnect function
depends on the availability of HomeConnect services
in your country. You can find information about this at:
www.home-connect.com.
The HomeConnect app guides you through the entire
login process. Follow the instructions in the HomeCon-
nect app to configure the settings.
Tips
¡ Please consult the documents supplied by
HomeConnect.
¡ Please also follow the instructions in the HomeCon-
nect app.
Notes
¡ Please note the safety precautions in this instruction
manual and make sure that they are also observed
when operating the appliance via the HomeCon-
nect app.
→"Safety", Page2
¡ Operating the appliance on the appliance itself al-
ways takes priority. During this time it is not possible
to operate the appliance using the HomeConnect
app.
¡ In networked standby mode, the appliance requires
a maximum of2W.
¡ If you need your device's MAC address to connect
to your home network, you can find this next to the
rating plate. →Page12
7.1 Setting up HomeConnect
Requirements
¡ The appliance is connected to the power supply and
is switched on.
¡ You have a mobile device with a current version of
the iOS or Android operating system, e.g. a smart-
phone.
¡ The mobile device and the appliance are within
range of your home network's Wi-Fi signal.
1.
Download the HomeConnect app.
2.
Open the HomeConnect app and scan the follow-
ing QR code.
3.
Follow the instructions in the HomeConnect app.
7.2 Resetting the connection, variant 1
▶
To reset the saved connections to the WiFi and to
HomeConnect, press and hold and at the
same time until goes out.
7.3 Resetting the connection, variant 2
▶
To reset the saved connections to the WiFi and to
HomeConnect, press and hold and at the
same time until goes out.
7.4 Software update
Your appliance's software can be updated using the
software update function, e.g. for the purposes of op-
timisation, troubleshooting or security updates.
To do this, you must be a registered HomeCon-
nectuser, have installed the app on your mobile device
and be connected to the HomeConnectserver.
As soon as a software update is available, you will be
informed via the HomeConnectapp and will be able to
start the software update via the app. Once the update
To Next Page
Loading...
Need help?
General
