Siemens Building Technologies RDF300.2/SRL 2016-08-22 1/2
Mounting locations
Mount the thermostat on a recessed square conduit box with fixed centers of 60.3 mm. Do not mount in niches
or bookshelves, behind curtains, above or near heat sources and wind outlets or inlets, and exposed to direct
radiation. Mount about 1.5 m above the floor.
Application settings and removal of front panel
2-pipe 4-pipe
If the unit is new, the front panel is separated from the mounting plate as shown in point 5 above. Select
applications according to the dip switch settings.
To remove the front panel, proceed as follows:
1. Insert the tool into the opening to disconnect the top of the front panel from the mounting plate.
2. Place the tool near the center at both sides and push inward.
3. Swing the top of the front panel downward.
4. Remove the panel from the mounting plate.
5. Check and select the desired applications (2-/4-pipe only) according to the dip switches shown.
RDF300.02/SRL
Mounting Instructions
for Shangri-la Hotels
Note: please refer to the installation
manual M3076 for more details
To Next Page
Need help?
General
