3/23
Siemens RDG1... Wall-mounted room thermostats with LCD CE1N3181en
Building Technologies 2017-11-20
Functions
∂ Maintenance of room temperature via built-in temperature sensor or external room
temperature/return air temperature sensor
∂ Automatic or manual changeover between heating and cooling mode
∂ Selection of applications via DIP switches
∂ Selection of operating mode via the operating mode button on the thermostat
∂ 1-speed, 3-speed or DC 0…10 V fan control (automatic or manual)
∂ Display of current room temperature or setpoint in °C and/or °F
∂ Minimum and maximum setpoint limitation
∂ Button lock (automatic or manual)
∂ 1 digital input, freely selectable for:
, Operating mode switchover contact (keycard)
, Automatic heating/cooling changeover contact
, Electric heater enable
, Dewpoint sensor
, Fault input
∂ 2 multifunctional inputs, freely selectable for:
, Operating mode switchover contact (keycard)
, Automatic heating/cooling changeover sensor
, External room temperature or return air temperature
, Dewpoint sensor
, Electric heater enable
, Fault input
, Supply air temperature sensor (RDG160T..)
∂ Advanced fan control function, i.e. fan kick, fan start, selectable fan operation
(enable, disable or depending on heating or cooling mode)
∂ Purge function together with 2-port valve in a 2-pipe changeover system
∂ Reminder to clean filters
∂ Floor heating temperature limit
∂ Minimum and maximum supply air temperature limitation (RDG160T..)
∂ Reloading factory settings for commissioning and control parameters
∂ 7-day time program: 8 programmable timers to switch over between Comfort and
Economy mode (RDG100T, RDG160T.., RDG100T/H)
∂ Infrared remote control (RDG100T, RDG160T.., RDG100T/H)
∂ Selectable relay function (RDG160T..)
, For switching OFF external equipment OFF during Protection mode
, For switching ON external equipment (such as. pump) during H/C demand
, Output heating/cooling sequence
∂ Wizard function to select working temperature unit °C or °F (RDG160TU, RDG110U)