Siemens RDJ10 User Manual

CE1B3071en / 05.07.2007 Subject to alteration Siemens Building Technologies / HVAC Products
Setting the first switch on time
1. Set the programming selector to position A1. The setting for the first
switch on time flashes.
2. Turn the setting knob counter-clockwise to decrease the time, or
clockwise to increase the time.
3. When the required switch on time is displayed, move the programming
selector to any other position to confirm your setting.
Setting the first switch off time
1. Set the programming selector to position A2. The setting for the first
switch off time flashes.
2. Turn the setting knob counter-clockwise to decrease the time, or
clockwise to increase the time.
3. When the required switch off time is displayed, move the programming
selector to any other position to confirm your setting.
Setting the second switch on time
1. Set the programming selector to position A3. The setting for the
second switch on time flashes.
2. Turn the setting knob counter-clockwise to decrease the time, or
clockwise to increase the time.
3. When the required switch on time is displayed, move the programming
selector to any other position to confirm your setting.
Setting the second switch off time
1. Set the programming selector to position A4. The setting for the
second switch off time flashes.
2. Turn the setting knob counter-clockwise to decrease the time, or
clockwise to increase the time.
3. When the required switch off time is displayed, move the programming
selector to any other position to confirm your setting.
NOTE
The switch on and off times are interrelated. When trying to
set a switching time to a time after the subsequent switching
time, the latter time will automatically be pushed forward
(or backward).
Setting the comfort temperature
1. Set the programming selector to position .
2. The setting for the current comfort temperature flashes.
3. Turn the setting knob counter-clockwise to decrease the
temperature setting, or clockwise to increase the temperature
setting.
4. When the required comfort temperature is displayed, move the
programming selector to any other position to confirm your setting.
Setting the energy saving temperature
1. Set the programming selector to position The setting for the
current energy saving temperature flashes.
2. Turn the setting knob counter clockwise to decrease the
temperature setting, or clockwise to increase the temperature
setting.
3. When the required energy saving temperature is displayed,
move the programming selector to any other position to
confirm your setting.
Changing temporarily the current setpoint
1. The current setpoint can be changed temporarily when the
operating mode selector is in the AUTO position and the
programming selector in the RUN position.
2. Turn the setting knob slightly in either direction to display the
current setpoint, then turn it counter-clockwise to decrease the
temperature setting, or clockwise to increase the temperature
setting.
3. This setpoint will be maintained until the next switching time. When
this has been activated, the hand symbol is displayed.
Changing the batteries
1. Get 2 new alkaline batteries type AA, 1.5 V.
2. Within 1 minute: Remove the battery holder, then the batteries,
insert the new batteries and replace the battery holder.
3. Make certain the old batteries are disposed of properly, in
compliance with environmental requirements.
Energy saving tips without sacrificing comfort
● Never allow room temperatures to exceed 21˚C
● Air out rooms for short periods of time only, but properly, with the
windows wide open

Siemens RDJ10 Specifications

General

Brand	Siemens
Model	RDJ10
Category	Thermostat
Language	English