Siemens SINUMERIK 840DE SL Operation/Programming

9
08/2005 Program Management
9.2 Mana
g
in
g
p
ro
g
rams with Sho
p
Turn on NCU
(
HMI Embedded
)
9
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl Operation/Programming ShopTurn (BAT) – 08/2005 Edition 9-379
9.2.3 Executing a G-code program from the USB-network-drive
If the capacity of your NCK work memory is already close to being
exhausted, you can also have G-code programs executed from the
USB/network-drives (e.g. memory stick).
In this way, instead of the entire G-code program being loaded into
the NCK memory, only the first part of it is loaded. Subsequent
program blocks are then continuously reloaded as the first part is
executed.
The G-code program remains stored on the USB/network-drive while
executing from it.
Sequential control programs cannot be executed from the
USB/network-drive.
 Open the Program Manager.
…
 Via the softkey, select the USB/network-drive or local USB
connection.
 Place the cursor on the directory that contains the G code
program you want to execute.
-or-
 Press the "Input" or "Cursor right" key.
The directory opens.
 Place the cursor on the G code program you want to execute.
Continue
>
Exec. from
hard disk
 Select the "Continue" and "Exec. from hard disc" softkeys.
ShopTurn now switches to "Machine Auto" mode and loads the G-
code program.
Cycle Start
 Press the "Cycle Start" key.
The machining of the workpiece is started (see Sec. "Machining a
workpiece".) The program contents are continuously reloaded into the
NCK work memory as the machining progresses.

Siemens SINUMERIK 840DE SL Specifications

General

Brand	Siemens
Model	SINUMERIK 840DE SL
Category	Control Systems
Language	English