Block search mode Meaning
Without calculation For a quick search in the main program.
Calculations will not be performed during the block search, i.e. the calculation
is skipped up to the target block.
All settings required for execution have to be programmed from the target
block (e.g. feedrate, spindle speed, etc.).
With program test Multi-channel block search with calculation (SERUPRO).
All blocks are calculated during the block search. Absolutely no axis motion
is executed, however, all auxiliary functions are output.
The NC starts the selected program in the program test mode. If the NC
reaches the specified target block in the actual channel, it stops at the begin‐
ning of the target block and deselects program test mode again. After con‐
tinuing the program with NC start (after REPOS motion) the auxiliary func‐
tions of the target block are output.
For single-channel systems, the coordination is supported with events run‐
ning in parallel, e.g. synchronized actions.
Note
The search speed depends on MD settings.
Note
Search mode for ShopMill programs
● The search variant for the ShopMill machining step programs can be specified via MD
51024. This applies only to the ShopMill single-channel view.
Machine manufacturer
Please observe the information provided by the machine manufacturer.
References
For additional information, please refer to the following documentation:
SINUMERIK Operate Commissioning Manual
Machining the workpiece
6.7 Starting machining at a specific point
Milling
206 Operating Manual, 08/2018, 6FC5398-7CP41-0BA0
To Next Page
Loading...
Need help?
General
