- 4 -
Using the thermal jug
Opening / Closing the lid
➪ To open the thermal jug 0, turn the lid 9 so
far to the side that the arrow on the lid 9 points
to the symbol . You can now lift the lid 9
upwards.
Risk of personal injury!
Should you want to remove the lid 9 directly after
the brewing process, ensure that you hold the lid 9
so that the hot condensed water, which can collect
on the lid 9, is not able to run onto your hand. Risk
of scalding!
➪ To close the lid 9, place it so that the arrow on
the lid 9 points to the symbol . Then turn it
so far back that the arrow on the lid 9 points to
the symbol . The lid 9 is now secured and
cannot fall off.
Pouring coffee
You do not have to remove the lid 9 from the thermal
jug 0 to pour coffee.
➪ With the lid 9 secured, press on the pouring
lever 8 and hold it down. You can now
pour out the coffee.
➪ When you have finished pouring, release the
pouring lever 8 .
Preparing coffee
➪ Swing out the filter holder 4 and insert a filter
bag (Size 1x4) with the sides folded. Put coffee
powder into it (medium to fine ground). For one
cup of coffee you will require about one measuring
spoon q of coffee powder. Subject to taste, the
amount of coffee powder can vary.
➪ Fill the water tank 1 with the required amount
of water.
For this, use the scale 3 on the water tank 1.
Note:
• Never fill it with water for more than 10 large
cups/ 15 small cups. Pay heed to the Max
marking in the water tank. The appliance can
overflow. Before use, check to ensure that the
thermal jug 0 is empty.
• Before every brewing process, rinse the thermal
jug 0 with hot mains water. This will ensure that
the coffee remains hot for longer.
➪ Press the pouring lever 8 and place the
thermal jug 0 in the coffee maker. Then release
the pouring lever 8 .
➪ Press the switch 7 to start the brewing process.
The red indicator lamp glows.
➪ The coffee maker switches itself off automatically
when the brewing process has ended.
Note:
You cannot stop the brewing process manually.
All of the water that is in the water tank 1 passes
through the coffee maker. Should you wish to stop
the brewing process you must disconnect the plug
6 from the power socket.
➪ You can extract the thermal jug 0 and serve the
coffee when the red indicator light has extinguished.
Note:
After you pour water in the water tank 1 for further
brewing processes, allow the coffee machine to
cool down for approx. 1 minute.
To Next Page
Loading...
Need help?
General
