Silvercrest SHT 2000 A1 User Manual

SHT 2000 A1 63
7. Cleaning
To ensure your appliance gives you lasting
service, you should clean it regularly.
Warning! To avoid the danger of
an electric shock or burning:
– remove the mains plug before
each clean;
– allow the appliance to cool
down;
– never immerse the appliance in
water;
– never allow water or cleaning
agent to run into the appliance.
1. Carefully remove major dust deposits in
the air outlet grille 4 with a vacuum
cleaner.
2. Remove any remaining dirt with a soft
brush.
Take care not to let any dust fall inside
the appliance.
3. Take off the air intake grille 9.
4. Clean the dust off the air intake grille 9
and the filter grille located behind it.
5. Clean the outside of the appliance with
a damp cloth. You could also use a little
washing-up liquid.
Caution! Never use caustic or abrasive
cleaning agents, as this could damage
your appliance.
6. Wipe the appliance with a cloth
moistened with clear water.
7. Do not use the appliance again until it
has dried completely.
8. Troubleshooting
Fault Cause Remedy
Appliance cannot be
switched on
Faulty fuse or wall socket Select another wall socket
Faulty appliance Have repairs carried out at a specialist
workshop or dispose of the appliance.
You will find the service address in
“Service Centre” on page 66.
Appliance cannot be
switched off
Faulty electronic components Have repairs carried out at a specialist
workshop or dispose of the appliance.
You will find the service address in
“Service Centre” on page 66.
Appliance switches
off automatically
Safety switch has triggered Set the appliance upright (see
“6.9 Safety switch” on page 62)
Thermal cut-out has
triggered
Allow the appliance to cool down (see
“6.8 Thermal cut-out” on page 62)
Clean the appliance (see
“7. Cleaning” on page 63)
RP75978 Heiztower LB1 Seite 63 Mittwoch, 29. August 2012 3:44 15

Silvercrest SHT 2000 A1 Specifications

General

Brand	Silvercrest
Model	SHT 2000 A1
Category	Heater
Language	English