© 2015 Tyco Fire Protection Products. All rights reserved. Specifications and other information shown were current as of publication and
are subject to change without notice.
TYCO, SIMPLEX, and the product names listed in this material are marks and/or registered marks. Unauthorized use is strictly prohibited.
579-1172
Rev. A
\
Introduction The Color Touchscreen LCD Annunciator for 4007ES panels* provides remote annunciation of
the Fire Alarm Control Panel (FACP) status. Visual status is provided by the touchscreen and by
the LEDs. Audible annunciation is provided through a piezo sounder. Access to Annunciator
switch functions can be enabled or locked using the keyswitch. A maximum of six color
touchscreen annunciators can be installed on a 4007ES panel.
* 4007ES panels include the 4007ES hybrid panels and the 4007ES panels with IDNAC
notification. From this point on, they will be referred to as 4007ES.
Compatibility The 4007ES panel needs to be at revision 3.02.07 or higher to support the Color Touchscreen
LCD Annunciator.
The following annunciators, boxes, and brackets are compatible with 4007ES panels:
Reference
Documents
Refer to the following documents for more information on how to program and use the remote
annunciator.
Cautions
and Warnings
READ AND SAVE THESE INSTRUCTIONS- Follow the instructions in this installation manual. These instructions
must be followed to avoid damage to this product and associated equipment. Product operation and reliability depend upon
proper installation.
DO NOT INSTALL ANY SIMPLEX® PRODUCT THAT APPEARS DAMAGED- Upon unpacking your Simplex
product, inspect the contents of the carton for shipping damage. If damage is apparent, immediately file a claim with the car-
rier and notify an authorized Simplex product supplier.
ELECTRICAL HAZARD - Disconnect electrical field power when making any internal adjustments or repairs. All repairs
should be performed by a representative or authorized agent of your local Simplex product supplier.
FCC RULES AND REGULATIONS – PART 15 - This equipment has been tested and found to comply with the limits for a Class A digital device
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accor-
dance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to
cause harmful interference in which case the user will be required to correct the interference at his own expense.
Part Number Description
4606-9202 Color Touchscreen LCD Annunciator, Red
4606-9205 Color Touchscreen LCD Annunciator, Platinum
2975-9461 Color Touchscreen LCD Annunciator, Surface Mount Box, Red
2975-9462 Color Touchscreen LCD Annunciator, Surface Mount Box, Platinum
2975-9463 Color Touchscreen LCD Annunciator, Retrofit, Semi-flush bracket, Red
2975-9464 Color Touchscreen LCD Annunciator, Retrofit, Semi-flush bracket, Platinum
In this
publication
Reference Documents ................................ 1 Wire Length Tables ..................................... 5
Module Overview ........................................ 2 Communication Wiring Length Tables ........ 6
General Mounting Information .................... 3 Address Setting ........................................... 6
General Wiring Guidelines .......................... 3 Mounting Instructions .................................. 8
Specific Wiring Guidelines .......................... 3 Verification Procedure ................................. 8
Wiring .......................................................... 4 Remote Annunciator Specifications ............ 9
Document Number Title
579-1165 4007ES Operator’s manual
579-1167 4007ES Programmer’s manual
Document: Installation Manual
Part: Color Touchscreen LCD Annunciator
Product: 4007ES Panels
To Next Page
General