To Next Page

To Previous Page

Note: Sometimes two dierent gear pockets are away from alignment by

exactly the same distance – this indicates that the current code uses two dier-

ent number buttons (example, 2 and 4) depressed at the same time as part of

the code combination.

Using a small at blade screw driver or your thumbnail, depress the key

stem which corresponds to the gear pocket which has been rotated the

farthest away (out of alignment) from the “L” shaped leg. When

depressed, the key stem(s) should stay down and the corresponding

gear pocket(s) should move closer to its corresponding “L” leg, closer to

alignment. Record the key stem number. This is the rst number of your

combination.

Note: If two gear pockets are at the same distance, depress both of these

corresponding key stems at the same time.

Continue by pressing the key stem that corresponds to the gear pocket

that was the next furthest away (do not include gear pockets that have

already been rotated). Record each key stem number that is depressed.

Continue this procedure until all ve gear pockets are aligned with their

corresponding “L” shaped legs on the unlocking slide. The combination

is the recorded numbers, in the order recorded.

Note: If you depress the wrong key stem by mistake, rotate the reset cam back

toward you, (toward the key stems and release). This resets the code gears and

you must repeat the above procedure, Step 3.

4. Clearing the Current Code and Setting a New Code

Note: Align the code gear pockets with the “L” shaped legs.

Depress the code change button (i) located on top of the combination

chamber once and release (see gure 6).

Rotate the reset cam back toward you with your nger (toward the key

stems) as far as it will go and release.

Enter your new combination code by depressing the key stem

corresponding to the rst number (1 through 5) of your code. For

example, if the new code is 3-2-5, then you would depress 3 rst, then 2

and nally 5. Record this new combination code for future reference.

Push the shoulder (j) at the bottom of the Unlocking slide up toward the

code change button and release. If each of the 5 “L” shaped legs of the

unlocking slide engages snugly inside its corresponding code gear

pocket, then it conrms that the new code has been successfully

changed. Rotate the reset cam (g) back toward you and release.

Note: If all 5 “L” shaped legs do not align fully with their corresponding

code gear pockets, repeat the procedures 3 and 4.

Simplex 5000 Series User Manual

Questions and Answers: