SJCam SJ4000 WiFi Manual
GENERAL NOTES
When you open the camera package for the first me check the contents to make sure you have all
the mounng hardware and accessories.
Plasc film covers the camera display and lens. There is also plasc film on the inside and outside of
the lens cover and both back cover doors of the clear housing. Remove plasc filmbefore using the
camera.
Verify the authencity of the camera by checking the security code under the scratch-off on the side
of the package. Go to the SJCam official website at hp://www.sjcamhd.com/safe/ and enter the
security code as directed to verify that you have an authenc SJCam.
This manual is based on firmware version G20150408V02 dated 2015 April 8. Camera menus, sengs
or other operaons might vary with other firmware versions.
Notes are idenfied in parentheses () and are described at the end of each secon.
EXTERNAL LIGHTS
The following lights indicate the operaon described and can occur in several combinaons.
Blue light on: camera is on.
Red light on: camera is connected to a charger.
Amber light on: camera is connected to a smart device via WiFi.
Blue light flashing: camera is recording video.
Amber light flashing rapidly: camera WiFi is turned on but not connected to a smart device.
Amber light flashing: camera is connected to WiFi while recording video.
Red and amber lights on:WARNING – There is a serious problem with charging. Disconnect the
charger immediately due to the risk of severe overheang.
Blue light
Red light
Amber light
To Next Page
Need help?
General
Weight and Dimensions
