To Next PageTo Next Page
Need help?Do you have a question about the Skipper CU-M001-SA and is the answer not in the manual?
General| Brand | Skipper |
|---|---|
| Model | CU-M001-SA |
| Category | Touch Panel |
| Language | English |
Explains how the DL2 system uses the Doppler principle to measure speed.
Covers speed measurement, alerts, distance traveled, and trip counters.
Details on operating the control unit and system maintenance procedures.
Discusses built-in tests (BIT) for performance analysis and warning indicators.
Introduction to the 5 main runtime pages (A-E) and the optional 'page 2.nd system'.
How to change pages using navigate arrows and adjust screen brightness settings.
Details on primary data, user selectable, resultant/direction, docking, and depth pages.
Explains displaying STW from DL1 in DL21 dual system configurations.
Provides an overview of speed, mounting, tilt, and temperature calibration status.
Details on measuring and adjusting the sensor's installation angle for accuracy.
Explains manual and sea test calibration procedures for SOG and STW.
Covers adjusting temperature offset and nulling tilt sensors for accurate measurements.
Details on setting and adjusting high speed and low speed alerts.
Information on system alerts, their causes, and how to acknowledge them.
Guide on how to navigate to the 'Alert setup' pages from the config menu.
Covers system self-diagnostics, checking calibration, and recycling power for issues.
Explains simulators for speed/alert and system modes for optimal performance.
Details on using the Aux input to stop/mute the sensor and the 'M' symbol indicator.
Explains the 1% accuracy feature and its requirement for careful calibration.
Process for activating options by entering a code number in the DL2 Setup menu.
