Sloan EHD-511 SPOUT User Manual

2
1 - INSTALL SPOUT
HOLDING NUT
A
SSEMBLY
A
B
C
D
A
B
C
D
BASYS DRYER
SPOUT
LOCKING NUT
WASHER
A
B
C
D
BASYS DRYER
SPOUT
LOCKING NUT
WASHER
A
B
C
D
A
B
C
D
A
B
C
D
A
B
C
D
A
B
C
D
Remove holding nut assembly from the spout shank.
Unscrew counterclockwise.
Ensure the wires are located inside corresponding
slots on the sides of the spout shank. Insert spout
shank into the deck hole.
Holding the spout down on the sink deck, Spread wires
away from spout shank, align wires into grooves on
locking nut washer (1). Turn the locking nut until it
makes contact with the wires. Align spread wires in
corresponding relief grooves on top of the locking nut
washer.
(2) Spread the wires horizontally. Turn the locking nut
until snug making sure the wires are in the
corresponding wire relief grooves on the locking nut
washer. Align the spout as desired and tighten the
locking nut until the spout is rmly locked into place.
HOLDING NUT
ASSEMBLY
SPOUT
SHANK
1.
2.

Sloan EHD-511 SPOUT Specifications

General

Brand	Sloan
Model	EHD-511 SPOUT
Category	Dryer
Language	English