3
Equipment Description
Air Cleaner — Filters engine intake air.
Battery Cover — Remove to gain access to the battery.
Fuel Cap — Add unleaded fuel here.
Grounding Fastener — Consult your local agency having
jurisdiction for grounding requirements in your area.
Display Panel — The LED displays voltage, frequency
and records how many hours your generator has run (up
to 999.9). It also has a built in maintenance reminder that
displays every 50 hours.
Identification Label — Provides model and serial number of
generator.
Low Oil Indicator — This unit is equipped with a low oil
protection device. Oil must be at proper level for engine
to run. If the engine oil drops below a preset level, an oil
switch will stop the engine. Check oil level with dipstick.
Maintenance Cover — Remove to gain access to the
choke lever, spark plug and air cleaner.
Oil Drain Plug — Drain engine oil here.
Oil Fill Cap/Dipstick — Check and add engine oil here.
Oil Service Cover — Remove to gain access to the oil fill
and drain.
this switch to turn the QPT on or off.
Recoil Starter — Used to start the engine manually.
Retractable Handle — Press button and pull handle out to
move generator. Press button to push handle back in.
Spark Arrester Muffler/Exhaust — Lowers engine noise and
is equipped with a spark arrester screen.
Start Button — Push and hold for one second to start
generator.
Starting Dial — Move dial to COLD START when starting
a cold engine. Move dial to RUN when restarting a warm
engine or after engine starts. Move dial to OFF to stop
engine, during storage and transporting.
Fuel Cap
Grounding Fastener
Starting Dial
Air Cleaner (under cover)
Maintenance Cover
Battery Cover
Oil Fill Cap/Dipstick (under cover)
Oil Drain Plug (under cover)
Identification Label
Recoil Starter
Spark Arrester Muffler/Exhaust
Retractable Handle
Low Oil Indicator
QPT Switch
Oil Service Cover
Display Panel
Start Button
To Next Page
Loading...
Need help?
General
