http://www.remotecontrol-
Program
ming of your new remote control
Receiver type 1 (fig.1):
1.
Open the casing of your receiver. It is located next to your motor.
2.
On the receiver circuit board, press the programming button «
light L1 on
the receiver illuminates.
3. Press a button on
your new remote control. Let it go. The LED light o
then turns off (4).
4. Wait 10 seconds.
5.
Your new remote control is programmed.
Receiver type Axroll (fig.2) :
1.
Open the casing of your receiver.
2.
On the receiver circuit board, press on the arrows until you get to the position P.8 on the
digital screen.
3. After
a second, the position 0.0 appears on the screen which corresp
function of your door.
4.
Simultaneously press the button you wish to program on your new remote control and the +
button in your receiver for three seconds.
go.
5. Wait 10 seconds.
6. Your new
remote control is programmed.
Programming Manual
- TEL : +44 (0) 207 399 7782 - FAX :
-
ming of your new remote control
:
Open the casing of your receiver. It is located next to your motor.
On the receiver circuit board, press the programming button «
Prog 1 »
the receiver illuminates.
your new remote control. Let it go. The LED light o
n
Your new remote control is programmed.
Open the casing of your receiver.
It is located next to your motor.
On the receiver circuit board, press on the arrows until you get to the position P.8 on the
a second, the position 0.0 appears on the screen which corresp
Simultaneously press the button you wish to program on your new remote control and the +
button in your receiver for three seconds.
Two dashes appear on the screen. Let the buttons
remote control is programmed.
fig 2
On the receiver circuit board, press on the arrows until you get to the position P.8 on the
Simultaneously press the button you wish to program on your new remote control and the +
Two dashes appear on the screen. Let the buttons
To Next Page
Need help?
General
