DR-EX39PP_E [GB, CT, KR] 4-256-084-21(1)
Stereo Headset
DR-EX39PP
©2010 Sony Corporation Printed in Thailand
4-256-084-
21
(1)
Operating Instructions
使用說明書
Coloured parts
彩色部分
Sectional View
剖面圖
1
2
a
b
c
1
2
English
Stereo Headset
Features
Stereo Headset with in-line microphone and answer/end
button for hands-free phone calls.
Easy to use volume control.
3 sizes of earbuds (S, M, L) supplied for stable and
comfortable fit in the ear.
Hybrid silicone rubber earbuds for secure fit and long-
term wearing comfort.
Convenient cord adjuster supplied.
How to use (see fig. )
1
Connect the headset to the mobile phone.
Connection to the mobile phone can be made in accordance with
the Open Mobile Terminal Platform (OMTP).
Not compatible with iPod*, iPhone*, HTC or BlackBerry.
* iPod, iPhone, iPod classic, iPod nano, iPod shuffle and iPod
touch are trademarks of Apple Inc., registered in the U.S.
and other countries.
2
Wear the earpiece marked in your right ear, and
the one marked in your left ear.
There is a tactile dot on the unit marked to distinguish the left
side.
Using the cord slider
Move up and down to change the split position of the cord
(see fig.
-).
After you use the headset, keep it with the cord slider high
positioned to avoid entangling the cord.
Installing the earbuds correctly
If the earbuds do not fit your ears correctly, low-bass sound
may not be heard. To enjoy better sound quality, change the
earbuds to another size, or adjust the earbuds position to sit
on your ears comfortably and fit your ears snugly.
If the earbuds do not fit your ears, try another size. Confirm
the size of the earbuds by checking colour inside (see fig.
-).
When you change the earbuds, install them firmly on the
headset to prevent the earbud from detaching and
remaining in your ear.
Earbud sizes (inside colour)
Small
Large
S
(Orange)
M
(Green)
L
(Light blue)
To detach an earbud (see fig. -)
While holding the headset, twist and pull the earbud off.
Tip
If the earbud slips and cannot be detached, wrap it in a dry soft cloth.
To attach an earbud (see fig. -)
Push the parts inside of the earbud into the headset until the
projecting part of the headset is fully covered.
To clean the earbuds
Remove the earbuds from the headset, and wash them with
a mild detergent solution.
Using the microphone/controller (see fig. )
a: Microphone
Use to make a hands-free phone call.
b: Volume
Rotate upward to increase the volume and rotate downward to
decrease the volume.
c: Answer/End button
When receiving a phone call, push the button to speak. To
disconnect, push the button again.
Note
The usage of this button is different according to the mobile phone
used. For details, refer to the manual of the mobile phone.
Adjusting the cord length (see fig. )
You can adjust the cord length by winding the cord on the
cord adjuster.
(The cord can be wound to the cord adjuster up to 50 cm. If
you wind more, the cord comes off from the cord adjuster
easily.)
1
Wind the cord.
2
Push the cord into a slot hole to secure in place.
Note
Do not wind the plug or split section of the cord, as it will strain the
cord and may cause a wire break.
Specifications
Cord: 1.2 m (47
1
/4 in), Y-type / Plug: Four-conductor stereo
mini plug for OMTP* 3.5mm audio connector / Mass:
Approx. 3 g (0.11 oz) without cord
<Headphones>
Type: Closed, dynamic / Driver units: 9 mm, dome type
(CCAW voice coil) / Power handling capacity: 100 mW
(IEC**) / Impedance: 16 Ω at 1 kHz / Sensitivity: 100 dB/
mW / Frequency response: 6 – 23,000 Hz
<Microphone>
Design: In-line microphone / Type: Electret condenser /
Open circuit voltage level: -38 dB (0 dB = 1 V/Pa) / Effective
frequency range: 20 – 20,000 Hz
<Supplied accessories>
Cord adjuster (1) / Earbuds (S (2), M (2), L (2)) / Operating
Instructions (1)
* OMTP = The Open Mobile Terminal Platform (OMTP) is a mobile
network operators’ platform that has created an industry standard
for wired connectivity to improve compatibility between mobile
phones and phone headsets.
** IEC = International Electrotechnical Commission
Design and specifications are subject to change without
notice.
Precautions
Please keep your headset clean at all times especially
inside the rubber earbud (see fig. ).
If any dust or ear wax inside the earbud, you may
experience some listening difficulties.
Listening with headset at high volume may affect your
hearing. For traffic safety, do not use while driving or
cycling.
Do not put weight or pressure on the headset as it may
cause the headset to deform during long storage.
The earbuds may deteriorate due to long-term storage or
use.
Install the earbuds firmly onto the headset. If an earbud
accidentally detaches and is left in your ear, it may cause
injury.
Note on static electricity
In particularly dry air conditions, mild tingling may be felt
on your ears. This is a result of static electricity accumulated
in the body, and not a malfunction of the headset.
The effect can be minimized by wearing clothes made from
natural materials.
Optional replacement earbuds can be ordered from your
nearest Sony dealer.
繁體中文
立體聲耳機
特點
帶有線控麥克風和接聽 / 結束按鈕立體聲耳機，適合免
持通話。
容易使用音量控制。
隨附3種尺寸的耳塞（S、M、L），可以穩定舒適地貼合
在耳內。
混合矽膠耳塞貼合更牢固，且長時間聆聽也不會感到不
適。
隨附導線長度調節器，方便使用。
使用方法（見圖
）
1
將耳機連接到手機。
可以根據開放行動終端平台（OMTP）連接到手機。
與iPod*、iPhone*、HTC或 BlackBerry不相容。
*iPod、iPhone、iPodclassic、iPodnano、iPod
shuffle和iPodtouch是AppleInc.在美國和
其他國家註冊的商標。
2
將有
標記的耳機戴在右耳，
標記的耳機戴在
左耳。
標記的耳機上有一個觸覺點，能夠識別左側。
使用導線滑動器
上下移動來變更導線的開叉位置（見圖
-
）。
使用耳機後，將導線滑動器保持在高處，以免導線糾結。
正確安裝耳塞
如果耳塞無法正確貼合您的耳朵，您便可能無法聽到重低
音。為了享受更佳音質，請更換耳塞尺寸，或調整耳塞的
位置以舒適貼合您的耳朵。
如果耳塞不適合您的耳形，請更換耳塞尺寸。檢查內部顏
色以確認耳塞尺寸（見圖
-
）。
當您更換耳塞時，請將其牢固地安裝在耳機上以防止耳塞
脫落在您耳朵內。
耳塞大小（內部顏色）
小
大
S
（橘色）
M
（綠色）
L
（淺藍色）
拆掉耳塞的方式（見圖
-
）
拿著耳機，然後轉動耳塞，把耳塞拔出來。
提示
如果耳塞脫落，無法拆掉，請用柔軟的乾布包住耳塞。
安裝耳塞的方式（見圖
-
）
將耳塞內的組件推入耳機裡，直到完全覆蓋耳機突出部分
為止。
清潔耳塞
將耳塞從耳機體上拆下，並以中性清潔劑溶液清洗。
使用麥克風 / 控制器（見圖
）
a:麥克風
用於撥打免持電話。
b:音量
向上旋轉可增大音量，向下旋轉可降低音量。
c:接聽 / 結束按鈕
接收來電時，按下此按鈕以通話。若要中斷，再按一次
此按鈕。
注意
此按鈕的使用方式因使用的手機而異。
詳細說明，請參閱手機手冊。
調整導線長度（見圖
）
您可以將導線繞在導線長度調節器上以調節導線長度。
（導線最多可以在導線長度調節器上繞50cm。如果所繞的
長度超過此限制，導線容易脫離導線長度調節器。）
1
捲繞導線。
2
將導線推入槽孔以固定到位。
注意
請勿捲起導線的插頭或開叉部分，否則會繃壞導線並可能使導線斷裂。
規格
導線：1.2m，Y型 / 插頭：用於OMTP
*
3.5mm音訊接頭
的四導體立體聲迷你插頭 / 質量：不包括導線約3g
< 耳機 >
型式：封閉式，動態 / 激勵單元：9mm，圓頂型（CCAW音圈）
/ 功率處理容量：100mW（IEC
**
）/ 阻抗：1kHz時16
Ω/ 靈敏度：100dB/mW/ 頻率響應：6-23000Hz
< 麥克風 >
設計：線控麥克風 / 型式：駐極體電容式 / 開路電壓電
平：–38dB（0dB=1V/Pa）/ 有效頻率範圍：20-
20000Hz
< 附件 >
導線長度調節器（1）/ 耳塞（S（2）、M（2）、L（2））/ 使
用說明書（1）
* OMTP=開放行動終端平台 (OMTP) 是行動網路業者平台，為有線連
接建立業界標準，以改善手機與耳機的相容性。
**IEC=國際電工委員會
設計和規格如有變更，恕不另行通知。
注意事項
請隨時保持耳機的清潔，尤其是橡膠耳塞的內部（見圖
）。
如果耳塞有灰塵或耳垢，您可能會無法順利聆聽音樂。
戴著耳機用很高的音量收聽可能會影響您的聽力。
為了交通安全，切勿在駕車或騎車時使用耳機。
請勿將重物放置在耳機上或施加壓力，因為長時間存放
時可能會造成耳機變形。
耳塞可能會因為長期存放或使用而損壞。
將耳塞牢固地安裝在耳機上。如果耳塞不小心脫落在您
耳朵內，可能會造成傷害。
關於靜電的注意事項
天氣乾燥時，您的耳朵可能會出現輕微疼痛。這並非耳機
故障所造成的，而是由於您的身體積累靜電所致。
如果您穿著的衣物是由不易產生靜電的天然材料製成，就
可減少這種情況。
可向附近的 Sony 經銷商訂購選購的替換耳塞。
To Next Page
Need help?
General
