Sony ECM-W3 User Manual

Help Guide
Wireless Microphone
ECM-W3 / ECM-W3S
When the message “This accessory is not supported by the device and cannot be
used.” is displayed on the camera:
Do the following in the listed order.
Note
Make sure that the slide switch is located exactly at the “ANALOG,” “OFF,” or “DIGITAL” position. If the switch is located in
between, the receiver may not work properly.
5-055-395-11(1) Copyright 2023 Sony Corporation
Make sure that your camera is compatible with this unit.
For camera models compatible with this unit, visit the website at:
ECM-W3
https://www.sony.net/dics/ecmw3/
ECM-W3S
https://www.sony.net/dics/ecmw3s/
Note
In combination with any camera model that is not listed on the above website, the unit does not work.
1
To use a camera that is not compatible with the digital audio interface in combination with this unit, set the
slide switch on the receiver to “ANALOG.”
2
Clean the contacts on the receiver and the camera. When either or both of the contacts are soiled with dust
or the like, the camera may fail to detect that the receiver is attached. To clean the contacts, use a cotton
swab or a dry, soft cloth (e.g., a cleaning cloth). Do not use water or chemicals for cleaning.
3
36

Sony ECM-W3 Specifications

General

Type	Digital camera microphone
Bit rate	24 bit
Sample rate	48 kHz
Pop-filter included	Yes
Number of products included	2 pc(s)
Control type	Slider
Product color	Black
Device interface	Bluetooth/3.5 mm
USB connector type	USB Type-C
Connectivity technology	Wired & Wireless
Maximum operating distance	150 m
Power source	Battery
Battery life (max)	6 h