1-1
ENGLISH JAPANESE
ENGLISH JAPANESE
HDR-CX100/CX100E/CX105E/CX106E/CX120_L2
1. SERVICE NOTE
1-1. POWER SUPPLY DURING REPAIRS
In this unit, about 10 seconds after power is supplied to the battery terminal using the regulated power supply (8.4 V), the power is shut off so
that the unit cannot operate.
These following method is available to prevent this.
Method:
Use the AC power adaptor (AC-L200C/L200D).
1-3. PRECAUTION ON REPLACING THE VC-559 BOARD
DESTINATION DATA
When you replace to the repairing board, the written destination data of repairing board also might be changed to original setting.
Start the Adjust Manual in the Adjust Station and execute the “DESTINATON DATA WRITE”.
RESTORE DATA
When you replace to the repairing board, get the data from the former one.
Start the Adjust Manual in the Adjust Station and perform “RESTORE DATA” to get the data.
The data getting for this model is as follows.
• USB SERIAL No.
USB SERIAL No.
The set is shipped with a unique ID (USB Serial No.) written in it.
This ID has not been written in a new board for service, and therefore it must be entered after the board replacement.
Start the Adjust Manual in the Adjust Station and execute the “USB SERIAL No. INPUT”.
PAL/NTSC SETTING
Set S1001 of the VC-559 board to PAL or NTSC at the following positions.
The image doesn’t reflect at a wrong setting, it is necessary to do a correct setting.
Switch setting
S1001 ...................................... PAL (HDR-CX100E/CX105E/CX106E)
NTSC (HDR-CX100/CX120)
1-2. PRECAUTION ON REPLACING THE INTERNAL MEMORY (MS7304)
When replacing the internal memory (MS7304 that has been inserted in the MS-419 board), start the Adjust Manual in the Adjust Station and
execute the “INTERNAL MEMORY ADJUSTMENTS”.
S1001
VC-559 BOARD (SIDE B)
PAL
NT
To Next Page
Loading...
Need help?
General