Appendix (Volume 2)
1019
Macro File Editing Rules
Errors
If any of the following problems occur, it is not possible to recall the file.
Attempting to recall the file will produce an error message.
• If there is a syntax error.
• If a required parameter is not present.
For details of error messages, see “Error Messages” in Appendix (Volume 3).
Correspondence Between Events and Symbols
For details of events, see “Events” (page 902).
Event Symbol Using Continue
Cross-point selection in the auxiliary
bus control block
AuxXpt No
Cross-point selection in the auxiliary
bus control block in router control
mode
RouterXpt Yes
Cross-point selection in the cross-
point control block
MEXpt Yes
Auto transition and take in the
transition execution section
MEAutoTransition Yes
Cut in the transition execution section MECut No
Transition type selection TransitionType No
Next transition setting NextTransition No
Pattern limit on/off PatternLimit No
Fade-to-black execution FadeToBlack No
Auto transition and take in the
independent key transition execution
section
KeyAutoTransition Yes
Key insertion and deletion in the
independent key transition execution
section
KeyCut Yes
Independent key transition type
selection
KeyTransitionType No
VTR/DDR/clip start point setting StartTc Yes
VTR/DDR/clip playback Play Yes
VTR/DDR/clip stop Stop Yes
VTR/DDR/clip cue-up Cue Yes
VTR/DDR/clip fast forward FF Yes
VTR/DDR/clip rewind Rewind Yes
To Next Page
Need help?
General