User's manual Sony Personal Navigation System
Navigation - 41 -
3. Tap on the Select destination button.
The M
AP MENU opens. It shows the address of the destination
in the crosshair. If the destination in the crosshair is not
located on a road that is included in the map, you will be
shown the coordinates.
You have the following options:
This function is only available when GPS reception is possible
(The GPS-symbol must be GPS ready).
Tap the Start navigation button to start navigation to the
selected place.
Caution: Using this function while you are already navigating
deletes all current destinations (stage points and destination
point).
Tap the Save button to save the selected place. You may
then at any time select this place from the F
AVOURITES.
Tap the Search nearby button to search for a point of
interest near the selected place.
Tap the Add button to add the selected place to your
itinerary. The selected point will be marked by a little flag. It
will also be added to the list of route points of the R
OUTE
PLANNING
screen where it figures as destination point.
Using this function while you are already navigating causes an
immediate recalculation of your route.
Tap the Interim destination button to make the selected
point the next stage point of your itinerary. Your route will be
recalculated immediately and then navigation will continue.
Once you have reached the interim destination, navigation to
the original destination is resumed.
Tap on the Back button to return to the map view without
executing a function.
To Next Page
Loading...
Need help?
General
