Picture Profiles
76
Recording
The values when “Off” is selected at “SEL” of the PICTURE PROFILE menu are shown in bold face
(example:
Standard).
Picture Profile Items
PICTURE PROFILE SET
Items Subitems and setting values Contents
Profile Name
Changing the picture profile
name
Profile name Set the profile name in 8 characters at maximum.
You can use upper- and lowercase alphabetics,
numerics 0 to 9, - (hyphen), _ (underscore) and
space.
Matrix
Adjusting the color phase
over the entire area with
matrix operations
Setting
On / Off
Set to “On” to activate the color phase adjustment
function with matrix operations for the entire
picture.
Note
When this function is set to “Off,” Color Correction
is also set to “Off” in synchronization.
Select
Standard /High SAT / FL
Light / Cinema
Select the built-in preset matrix provided for
convenience.
Level
–99 to +99 (±0)
Adjust the color saturation for the entire picture
area.
Phase
–99 to +99 (±0)
Adjust the hue for the entire picture area.
R-G, R-B, G-R, G-B, B-R, B-G
–99 to +99 (±0)
Finely adjust the color phase for the entire picture
area by independently setting each of the factors.
Color Correction
Adjusting the color phase in
a specific area
Setting
On / Off
Set to “On” to enable the color phase adjustment
for a specific area. (Simultaneous adjustment of
multiple areas is not allowed. You can adjust it for
one area only.)
Area Detection
1)
Execute/Cancel
Execute to detect the color in the center of the
screen. The area centering around the detected
color of the range specified by “Target Width”
becomes the target area of Color Correction.
Area Indication
2)
On / Off
Set to “On” to display the Zebra 1 pattern for the
target area of Color Correction.
Target Phase
0 to 359 (130)
Manually adjust the center color for the target area
for Color Correction.
Note
When Area Detection is executed, this setting is
overwritten by the Area Detection result. Perform
fine adjustment with this item as required.
Target Width
0 to 90 (40)
Set the width of color phase for the target area for
Color Correction.
Level
–99 to +99 (±0)
Set the saturation for the color in the target area.
Phase
–99 to +99 (±0)
Adjust the hue for the color in the target area.
To Next Page
Loading...
Need help?
General
