AEP Model
UK Model
E Model
Australian Model
Chinese Model
SERVICE MANUAL
SPEAKER SYSTEM
SPECIFICATIONS
• The SA-VE215 system consists of one unit
of SA-WMS215 and five units of SS-MS215.
• This set is the Speaker section in HT-K170/
K215.
SA-VE215/WMS215/
SS-MS215
Photo: SA-WMS215
Photo: SS-MS215
SS-MS215 Front, center and rear speakers
Speaker system Full range, magnetically
shielded
Speaker units 5 cm cone type
Enclosure type Bass reflex
Rated impedance 8 ohms
Power handling 60 watts
capacity
(Maximum input
power)
Sensitivity level 84 dB (1W, 1m)
Frequency range 150 Hz - 20,000 Hz
Dimensions (w/h/d) Approx. 76 × 100 × 86 mm
including front grille
Mass Approx. 425 g
SA-WMS215 Subwoofer
System Active subwoofer,
Speaker system magnetically shielded
Speaker unit Woofer : 16 cm cone type
Enclosure type Acoustically Loaded Bass Reflex
Continuous RMS 50 W
power output
(8 ohms, 20 - 250 Hz)
Reproduction 32 Hz - 250 Hz
frequency range
High frequency 250 Hz
cut-off frequency
Input
LINE IN (input pin jack)
General
Power requirements 220 - 230 V AC, 50/60 Hz
Power consumptions 45 W
Dimensions (w/h/d) Approx. 240 × 285 × 355 mm
including front panel
Mass Approx. 8 kg
Design and specifications are subject to change without
notice
Ver 1.1 2003. 05
Sony Corporation
Home Audio Company
Published by Sony Engineering Corporation
9-929-500-12
2003E16-1
© 2003.05
To Next Page
Need help?
General
