©2013 Crestron Electronics, Inc.
15 Volvo Drive · Rockleigh, NJ 07647
800.237.2041 / 201.767.3400
http://application.market.com
For more information please contact our Crestron Application Market team at
applicationmarket@crestron.com. The information contained on this document is privileged
and confidential and for use by Crestron Authorized Dealers, CSP Members, A+ Partners
and Certified Integrated Partners only. Specifications subject to change without notice.
Manufacturer: Sony Imaging Products & Solutions Inc.
Model: BRC-X400/SRG-X series
COMPANY NAME:
Sony Imaging Products & Solutions Inc.
SUPPORT CONTACT:
Crestron driver support
EMAIL ADDRESS:
Crestron.driver@am.sony.com
NOTES:
SIMPLWINDOWS NAME:
Sony_BRC-X400_SRG-X_series
CATEGORY:
Camera
VERSION:
1.0
SUMMARY:
This module controls Sony BRC-X400, SRG-X series cameras by way of VISCA over
IP protocol.
GENERAL NOTES:
Using the provided sample program, you will be able to control up to 2 cameras by
selecting the camera (either Camera1 or Camera2) in Camera selection menu in
[System] tab.
This program works with the following models of Sony network camera products.
- BRC-X400, SRG-X400, SRG-X120, BRC-X401, SRG-201M2, SRG-X402, SRG-
HD1M2
Prior to building and transferring the firmware into the Crestron Control System, be
sure to set up the correct IP addresses of the camera in IP-ID-04 and IP-ID-05
UDP/IP Communications in Slot-07 of “Central Control Modules: DMPS3-4K-150C” in
the Program View of the SIMPL Windows project. Right click the UDP/IP
Communications object and then select “Configure devices ... (F6)”, go into [IP Net
Address] tab and then put the correct camera IP address in the “Default Address”
fields (see below pictures).