Stereo Headset
Operating Instructions
Manual de instrucciones
4-408-899-(1)
©2011 Sony Corporation
Printed in Thailand
XBA-1iP
Using the Center button
Plays/pauses a track of the connected iPod product
with a single press. Skips to the next track with a double
press. Skips to the previous track with a triple press.
Starts the “VoiceOver*” feature with a long press (if
available).
Press once to answer the call. Press again to end. Hold
down for about two seconds to reject an incoming call.
When you let go, two low beeps confirm the call was
rejected.
* Availability of the “VoiceOver” feature depends on
iPod and its software version.
Note
Be careful not to unintentionally press any buttons
when you carry your iPod with this unit connected.
Features
Earbuds with remote controller for iPod/
iPhone/iPad
Easy-to-use remote control (only for iPod, iPhone
and iPad)
Newly developed Balanced Armature driver
unit
Newly developed micro-size driver unit (full-range)
reproduces smooth and clear vocal sound.
Newly developed Double Layered Housing
Liquid Crystal Polymer inner housing and special
ABS outer housing reproduce clear, distortion-free
mid-high range.
Noise-blocking design
Noise-blocking design attenuates ambient noise and
sound leakage.
Super-small body
Balanced Armature driver unit allows for a super
small body, and ultimate wearing comfort.
Specifications
Headphones
Type: Closed, Balanced Armature
Driver unit: Balanced Armature
Power handling capacity: 100 mW (IEC*)
Impedance: 24 Ω at 1 kHz
Sensitivity: 108 dB**
English Stereo headset
To Next Page
Need help?
General
Weight and Dimensions
