Edition
2016
Workshop Manual
PARK 120 - PARK 220
Chapter
1 General instructions
Page
10
Charging by the engine
The battery can be charged by the machine’s alternator as follows:
1. Install the battery in the machine.
2. Position the machine outside or set up an exhaust fumes extraction device.
3. Start the engine in accordance with the indications in the instructions for use.
4. Leave the machine in continuous operation for 45 minutes (not applicable for completely
at batteries).
5. Stop the motor. The battery will now be fully charged.
Charging with a battery charger
When charging the battery with a battery charger, make sure it is a genuine STIGA battery
charger. The battery will be damaged if other battery chargers are used.
1.4.3 Final inspections
Interventions before start-up
Before starting the machine proceed as follows:
• Check/top-up the fuel.
• Check/adjust the engine oil level.
• Check the tyre pressure.
• Carry out safety checks.
• Test drive.
Test drive
The engine must run at minimum revs to reach the correct operating temperature before
carrying out the test drive. For more detailed instructions, refer to the instruction manual.
Operate the machine for a few minutes. Check all the various functions. In particular check
that the safety devices all work properly.
If a cutting device or other equipment is envisaged, these devices must be installed before
carrying out the test drive with the machine.
To Next Page
Loading...
Need help?
General
