FCB-KM
English
11
N Use the gunning sight (1) for the
cutting blade to align the blade to
the edge
KombiEngines
Only KombiEngines supplied by STIHL
or expressly approved by STIHL for use
with the specific model are authorized.
Only use this KombiTool with the
following KombiEngines:
STIHL KM 55 R, KM 56 R, KM 85 R,
KM 90 R, KM 94 R, KM 110 R,
KM 130 R
WARNING
For machines with a loop handle, the clip
(barrier bar) must be installed.
N Pull the protective caps off of the
ends of the shaft and keep them in a
safe place for later use – see
"Storing the Machine"
Connecting drive tube to gearbox
N Loosen the clamping screw (1) on
the gearbox – do not remove
N Insert curved end of drive tube (3) in
the gearbox (2), turn the gearbox
back and forth as necessary.
N Push the shaft (3) in as far as it will
go.
N Screw in the clamping screw (1) as
far as it will go – do not tighten yet!
Approved KombiEngines Assembling the Unit
To Next Page
Loading...
Need help?
General
