FCB-KM
English
16
Replacing the protection against wear
N Remove the blade – see "Fitting the
blade"
N Unscrew screws (4)
N Replace the protection against
wear (5)
N Screw in and tighten screws (4)
N Fit the blade – see "Fitting the
blade"
The following information applies in
normal operating conditions. The
specified intervals must be shortened
accordingly when working for longer
than normal or under difficult cutting
conditions (extensive dust, etc.).
All accessible screws, nuts and bolts
N check and retighten if necessary
Wheel
N Visual inspection, before starting
work
N Check that the wingnut is secure,
before starting work
N Have it replaced if necessary – see
"Replacing the wheel"
Skirt
N Visual inspection, before starting
work
N Replace if damaged – see
"Replacing the skirt"
Blade
N Visual inspection, before starting
work
N Check that it is secure, before
starting work
N If necessary, have it checked to see
if it is out of balance, replace if it is
out of balance – see "Replacing the
blade"
N Replace if damaged – see
"Replacing the blade"
Protection against wear
N Check before starting work
N Replace if necessary – see "Check
and replace protection against
wear"
Safety information label
N Replace illegible safety information
labels
Maintenance and Care