20
English / USA
HL 75, HL 75 K
: Pull the starter grip slowly with your
right hand until you feel it engage
and then give it a brisk strong pull.
Do not pull out the starter rope all
the way – it might otherwise break.
: Do not let the starter grip snap back.
Guide it slowly back into the housing
so that the starter rope can rewind
properly.
When engine begins to fire:
: Move the choke lever to e and
continue cranking.
As soon as engine runs:
: Blip the throttle trigger (2) – the slide
control (3) moves to the run position
# – and the engine settles down to
idle speed.
Make sure the carburetor is
correctly adjusted – cutting blades
must not run when the engine is
idling.
Your hedge cutter is now ready for
operation.
To shut down the engine:
: Move the slide control (3) to $
(STOP).
At very low outside temperatures
As soon as the engine runs:
: Blip the throttle trigger to disengage
the starting throttle position –
the slide control moves to the run
position # and the engine settles
down to idle speed.
: Open the throttle slightly and allow
engine to warm up for a brief period.
3
2
225BA005 KN
START
STOP
3
225BA006 KN
START
STOP
To Next Page
Loading...
Need help?
General
