13HT
English / USA
Preparations
: Wear suitable protective clothing
and equipment – see "Safety
Precautions".
: Start the engine.
: Put on the shoulder strap.
Never throw cuttings into the
household garbage can – they
can be composted!
Never stand directly under the
branch you are cutting – be wary of
falling branches. Note that a branch
may spring back at you after it hits
the ground!
Cutting sequence
To allow branches a free fall, always cut
the lower branches first. Prune heavy
branches (large diameter) in several
controllable pieces.
Working position
Hold the control handle with your right
hand, and the drive tube with your left
hand. Your left arm should be extended
to the most comfortable position.
The shaft should always be held at an
angle of 60° or less!
The most convenient working position is
a tool angle of 60°, but any lesser angle
may be used to suit the situation
concerned.
Cross-cutting
To avoid pinching the bar in the cut,
position the cutting attachment with the
hook against the branch and then
perform the cross-cut from the top
downwards.
Using the Pole Pruner
402BA012 KN
390BA052 KN
To Next Page
Loading...
Need help?
General
