64
English / USA
MS 280 C
In order to comply with the kickback
performance requirements of § 5.11 of
ANSI standard B 175.1-2000, do not use
replacement saw chain unless it has
been designated as meeting the ANSI
§ 5.11 requirements on this specific
powerhead, or has been designated as
"low kickback" saw chain
1)
in
accordance with the ANSI B 175.1-2000
standard.
Since new bar/chain combinations may
be developed after publication of this
manual, ask your STIHL dealer for the
latest recommendations.
Other bars and chains available for this
powerhead are:
STIHL yellow-labeled guide bars:
For 0.325" pitch:
Rollomatic with sprocket nose
40, 45 or 50 cm (16, 18 or 20")
Duromatic with stellite tipped nose
40, 45 or 50 cm (16, 18 or 20")
STIHL yellow-labeled chains:
For 0.325" pitch:
Rapid Micro (23/26 RM, 23/26 RMC)
Rapid Super (23/26 RS)
1)
See definition of "low kickback
chain" on page 19 of this manual
Contact your STIHL dealer for
information regarding special
accessories that may be available for
your product.
Please enter your saw model, serial
number as well as the part numbers of
the guide bar and saw chain in the
spaces provided. This will make
re-ordering simpler.
The guide bar and saw chain are subject
to normal wear and tear.
When purchasing these parts, always
quote the saw model, the part numbers
and names of the parts.
Model
Serial number
Guide bar part number
Chain part number
For recommended STIHL reduced
kickback cutting attachments
see section “Specifications“
of this Owner’s Manual.
Special Accessories Ordering Spare Parts
To Next Page
Loading...
Need help?
General
