DOOR PANEL HEIGHT
Door panels can grow beyond the 80-inch height to
accommodate any size of door as long as you stay
below the recommended door panel weight limit of
40 pounds.
Illustration 10 shows how the panel may grow and
what you need to consider doing to finish the area in
back of the door panel.
IMPORTANT NOTE: The valance you use to finish the
area behind the door panel must stay behind the front
plane of the finished molding as noted in illustration
10.
KICKPLATE CLEARANCE
Illustration 11 details the area below the lower draw-
er area where the operating mechanical equipment of
the Sub-Zero 700 Series unit is housed.
IMPORTANT NOTE:You must keep a minimum space
of four inches clear below the bottom edge of the
lower drawer panel, so the unit can be properly vent-
ed. In addition, any decorative base molding must be
removable for possible servicing and cleaning of the
condenser.
Illus. 10
Illus. 11
DUAL INSTALLATIONS
Optional components are necessary for the installa-
tion of two or more 700 Series units, where there is
two inches or less of space between the units.
Contact your Sub-Zero distributor for the proper com-
ponents and instructions. Note that panel sizes will
change, refer to illustration below.
To Previous Page
Loading...
Need help?
General
